HE4000 Encoding System
Conditional Access
B.10 Manage the IRD List
View the IRD Conditional Access List
3.
Type tca list and press Enter.
Add IRDs to the Conditional Access List
4.
Type tca add <decoder name>@<decoder TMA Address> and press Enter.
Decoder names are limited to 15 characters in length or less. Decoders are automatically
authorized when they are added to the list.
5.
Repeat for all required decoders.
Delete IRDs from the Conditional Access List
6.
Type tca delete <decoder name> and press Enter.
Enable Individual IRDs
An enabled, or authorized, decoder will be able to unscramble the incoming transmission from the
encoder.
8.
Type tca auth <decoder name> and press Enter.
9.
Repeat for all required decoders.
Disable Individual IRDs
A disabled, or deauthorized, encoder will not be able to unscramble the incoming transmission
from the encoder.
10.
Type
tca deauth
<decoder name> and press Enter.
11.
Repeat for all required decoders.
HE4000 is Now Processing Using the Current PGCA Configuration
12.
PGCA is now enabled and will continue to use the current PGCA configuration until
PGCA is disabled (tuned off) or the PGCA configuration is changed.
Save the Current PGCA Configuration
13.
Save the current PGCA configuration to either:
• Flash memory using the CM Save command.
• A user-defined configuration set, using the cm create and
cm save_cfg commands..
Any parameter changes, including conditional access changes, that are made using a
remote unit are not automatically stored in flash memory. When the HE4000
configuration is changed using a remote unit, an operational test should be performed to
verify that the system is operating correctly. Then the new configuration should be saved
by issuing the CM SAVE command.
01-0951-404 Rev B
B-
9
