Using the Front Panel
HE4000 Encoding System
3.15 HE4000 Procedures
This section provides detailed steps for performing various HE4000 tasks.
Before beginning initial HE4000 installation and configuration, the
modulator output (Mod State) should be turned off until ready to begin
satellite transmissions.
3.16 Configuration Sets
3.16.1 Restoring a Default Factory Configuration
To restore a default configuration and set the table types:
1.
From the main menu, select [QuickSet]. The Configuration menu appears.
2.
Select Default, The Default restore menu displays.
3.
Select Enter to restore the default configuration or Exit to abort.
The reconfiguration process may take up to two minutes. When the system has
completed its configuration process, the LCD returns to the main menu.
The operating parameters in use at the time the restore process is
executed are overwritten and will be lost if not previously saved as a
configuration set.
01-0951-404 Rev B
3-35
