9
10
Step1 Take out the chair
Take out these pads from packing box, chair body, cushion, pillow, left/right armrests,
remote control holder, cables, etc. It needs 2 people to take the chair body out. Hold
the metal frame (Point out in below picture
and take the main body out from
box slowly
)
.
Refer to pictures
(
)
Step2 Set the main body
Raise the back to 120 degree until you hear a
click
sound
“
”
.
Main body
▲
Step4 Connect seat air pipe
Connect the air pipes in seat and those insert frame as per color (black to black
gray with
gray
brown with brown
Then stick the snap fastener together
,
,
).
.
Step3 Install manual control holder and insert manual control
Using three screws (M5*15) to fix the manual control to right upper arm, then insert the
manual control into the bracket and fix the manual control cables to the buckle at the end of arm.
Align control holder and marking line.
control
VFD control
Seat cushion
Manual control holder
Cable
Back cushion
Pillow
Hold here to take out
Don t take this out
when you take out
the chair
'
In
st
all
at
io
n
In
st
alla
ti
o
n
Installation
Installation
Installation
（
1
）
Installation
（
2
）
Control holder
Seat cushion
Tawny air pipe
Black air pipe
