23
Chapter 4
Initial Configuration
(Console/Telnet)
This chapter describes how to configure the device for the first time in the
console/Telnet session. It includes initial configuration, quick configuration,
basic configuration and ADSL characteristics parameters. For advanced
configurations, refer to Chapters 5 to 11.
4.1 Initial
Setup
This section describes how to configure the fundamental features of the device.
The default settings of these features are listed below. To change the settings,
enter the
MAIN/CONF/SYSTEM
menu, and refer to the relevant sub-sections.
Co chipset: ADI
Console password check: Disabled
Login name and passwords:
root/root (for administrator with read-write access)
user/user (for common user with read-only access)
Operation mode: Bridge
Physical mode: ANSI (full rate)
If you change the configurations, write the new parameters from the
MAIN/WRITE
menu and then reboot the device.
4.1.1
Bridge and Router Mode
Enter the
MAIN/CONF/SYSTEM
menu. In the
Operation Mode
field, select
bridge
or
router
for the CT-510. If bridge mode is selected, the IP address of
the LAN interface is considered the bridge IP, and the IP addresses of the ATM
interfaces are not applicable. The default operation mode is bridge mode.
4.1.2 CO
Chipset
In the
CO Chipset
field, select the CO DSLAM manufacturer to be ADI, Alcatel,
or TI.
