56
12.2.2 Basic
Configuration
At this stage, the administrator can perform the following functions:
Load Factory Default
System Parameters
(host name, domain name, operation mode,
ADSL physical mode, user password)
ISP Parameters
ATM VC Parameters
ATM Interface Parameters
DHCP Parameters
NAT Parameters
Review Parameters
Save and Restart
Step 1
Click the
Config
button to access the Basic Configuration page.
Figure 12-3 Basic Configuration
Step 2
The Basic Configuration page allows you to load the factory default
settings (default IP 215.65.231.206 and baud rate 9600 bps) or
configure the other functions by following the online explanations.
Step 3
After the parameters are set up, the page will display all the adjusted
settings for you to review.
Step 4
Click the
Finish
button to confirm the settings.
Step 5
The system will prompt you to save (write) the configurations in the
system flash memory and then restart the system to make the new
parameters effective. Click the
Save
button and then the
Restart
button as instructed.
12.2.3
Advance
Configuration
On the Advance Configuration page, you can perform the following functions:
