Configuring the DeviceMaster UP
DeviceMaster UP User Guide
: 2000451 Rev. C
- 23
Uploading Protocol-Specific Firmware on the DeviceMaster UP
5.
Select
Yes
to upload the firmware.
6.
Select
OK
to the advisory message about waiting until the DeviceMaster UP is
on-line and in the next minute the DeviceMaster UP unit or units should
display
ON-LINE
in the
Status
field
7.
Go to the appropriate
for your protocol for
information about configuring the serial port or ports and programming your
PLCs.
8.
After configuring the serial port characteristics and preparing your PLC
programs, you can use the next section in this guide, to attach the serial device
or devices.
