Hardware Installation
8
FCC Notices
9.
Select
Port 1
. You should see RING and CONNECT messages.
10. Any keys you press while looking at Port 1 display when you look at Port 2.
Likewise, any keys you press while looking at Port 2 display when you return
to the Port 1 display.
11. To exit, on either of the ports enter the escape sequence
+++
. This enables you
to enter
ATH
to hang up, or any other valid AT command string.
If you do not hang up, you can return to the still-active connection by entering
ATO
.
12. To exit terminal mode and return to the port menu, press
Esc
.
FCC Notices
Radio Frequency
Interference (RFI)
(FCC 15.105)
This board has been tested and found to comply with the limits for Class A digital
devices pursuant to Part 15 of the Federal Communications Commission rules.
The RocketModem III generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with this board, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, you are encouraged to try and
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Labeling
Requirements (FCC
15.19)
The RocketModem III complies with part 15 of FCC rules. Operation is subject to
the following two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received, including interference that
may cause undesired operation.
Modifications (FCC
15.21)
Changes or modifications to this equipment not expressly approved by Comtrol
Corporation may void the user's authority to operate this equipment.
Cables (FCC 15.27)
This equipment is certified for Class A operation when used with unshielded
cables.
FCC Part 68 Notice
1.
This equipment complies with Part 68 of FCC rules. On the bottom panel of
the unit is a label containing the FCC registration number, ringer equivalence
number, and the USOC jack code.
2.
The RocketModem III uses FCC compliant modular plugs, it is designed to be
connected to the telephone network or premises wiring using a compatible
modular jack which is FCC Part 68 compliant.
3.
If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service
may be required. But, if advance notice is not practical, the telephone
