INSTALLATION
TRI-AXIS GIMBAL
360º
90º
360º
CONNECTION
Connect the video out port to your video cable
running to the monitor / recorder
Check the power supply is of the correct level
and connect your power supply into the power
port on the Camera.
View the picture on a monitoring device to
check the power and video connection is
working properly.
PSU
Troubleshooting
Ensure all power and cable connections are correct with the Camera and DVR.
If all power and cable connections are correct and the camera picture can not be
produced then contact your supplier for technical support.
To assist in installation when using an
analogue test monitor, the camera can
be switched to an analogue output by
pushing the joystick fully up for
several seconds.
The camera can be returned to AHD
output by pushing the joystick fully
left for several seconds, or TVI output
by pushing it right for a few seconds.
Summary of Contents for CVP9324-AHD
Page 9: ...DIMENSIONS 52 36 95 149 46 00 83 105 ...
Page 10: ...NOTES ...
Page 11: ...NOTES ...
Page 12: ...OCTOBER 17 Design and specification are subject to change without notice ...
