FRANÇAIS
ENGLISH
ENGLISH
FRANÇAIS
FRANÇAIS
ENGLISH
ENGLISH
FRANÇAIS
CAUTION:
Keep tool pointed in a safe direction at all times.
Never attempt to drive fasteners into materials too hard to penetrate, or at too
steep an angle, or too near the edge of the workpiece. The fastener can rico-
chet causing personal injury.
Disconnect tool from air supply before doing any disassembly, maintenance,
clearing a jammmed fastener, leaving the work area, moving the tool to another
location, or handing the tool to another person.
Clean and inspect the tool daily. Carefully check for proper operation of trig-
ger and safety mechanism. Do not use the tool unless both the trigger and the
safety mechanism are functional, or if the tool is leaking air or needs any other
repair.
2. Make sure the air pressure is within the limits mentioned in SPECIFICATIONS.
3. Hold the BODY and press DRIVE GUIDE against the work surface, being sure
the tool is perpendicular to the surface.
4. Gently squeeze the TRIGGER to drive the fastener.
4. Gently squeeze the TRIGGER to drive the fastener.
5. Lift the tool off the work surface.
5. Lift the tool off the work surface.
WARNING:
WARNING:
Before any maintenance or adjustments to your air compressor, always
take the following safety precautions:
take the following safety precautions:
1. Disconnect electrical power.
2. Open the drain cock to drain air tank of pressure.
2. Open the drain cock to drain air tank of pressure.
DAILY MAINTENANCE
Before each use:
1. Be sure all nuts and bolts are tight
2. Check for any unusual noise or vibration
After use:
Open the air tank drain cock to drain condensation from tank:
Moisture in compressed air will form into droplets as it comes from an air compressor
pump. When humidity is high or when compressor is in continuos use for an
extended period, this moisture will collect in the tank. If left in tank over an extended
period, moisture will cause corrosion inside of the tank. To prevent corrosion, drain
tank after each use. To drain, open the drain cock located on the bottom of the tank.
After draining is complete, be sure to tighten drain cock before compressor is used
again.
MONTHLY MAINTENANCE:
1. Inspect air system for leaks by applying soapy water to all joints. Tighten those
joints if leakage is observed.
2. Check that all nuts and bolts stay tight.
CAUTION:
All air line components (including hoses, pipe, connectors, fi lters, & regulators,
etc.) must be rated for a minimum working pressure of 150 psi / 1034 kPa / 10.3
bar or 150% of the maximum system pressure, whichever is greater.
Disconnect any tools from the air supply before performing maintenance, clear-
ing a jammed fastener, leaving the work area, moving the tool to another loca-
tion, or handing it to another person.
!
SETUP & OPERATION
SETUP & OPERATION
COMPRESSOR MAINTENANCE
COMPRESSOR MAINTENANCE
!
!