EN
52
IDV2660
Improper cleaners
Never use Coarse sponges, abrasive agents or aggressive cleaners such as the spray for cleaning ovens and stain
remover.
Scraper for glass
Tough dirt should be removed preferably by means of a glass scraper.
Release the scraper.
Clean the heating plate with the edge only.
The holder of the scraper could scratch it.
WARNING!
The scraper is very sharp. Danger of injury! After cleaning, secure the scraper again.
If the edge is damaged, release it immediately.
Metallic-gloss colouring
Metallic-gloss colouring appears after the use of unsuitable cleaners or abrasion of a cooking utensil bottom.
Its removal is very difficult. Use Stahl-Fix or Sidol for ceran+steel. Removal of this colouring in our service centres is
charged for.
Control panel
Keep the panel clean and dry.
Food residue and food that has boiled over may affect the performance of the controls
UNIT INSTALLATION
• Only the customer is responsible for installation in situ. Defects caused by incorrect installation are not covered by the
warranty.
• The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
• To ensure the correct function of the unit, place it in suitable furniture.
• The unit should be installed in standardised kitchen furniture designed for built-in appliances or in properly adapted
furniture of dimensions according to Fig. 1 and 2.
• The kitchen furniture must be made of sufficiently heat-resistant material. The materials and adhesives used must be
resistant to heating of the unit according to standard ČSN EN 60335-2-6. Materials and adhesives that do not meet
the stated standard may deform or loosen.
PFollow the installation instructions:
1. Remove all the covering and marketing materials from the unit before the first use. Install the heating plate in
a cut-out in the worktop of a minimum thickness of 38 – 40 mm, with the surface covered with a heat-resistant
material. The worktop must be installed horizontally and at the wall it must be sealed against leaking liquids.
Ovens, the combustion products of which could flow up under the heating plate, cannot be installed under the
heating plate without taking special measures.
2. The required dimensions of the built-in hole in the worktop are on Fig. 1. Leave min. 50 mm space for the
adjacent cabinets on the sides. Leave at least 50 mm free space behind the heating plate.
EN
53
3. We recommend installing a vapour absorber above the heating plate; a top box can be located above it. The
minimum distance of the vapour absorber above the heating plate is 600 mm. Install a separate box without the
vapour absorber min. 760 mm above the heating plate.
4. For installation use a worktop with a minimum thickness of 38 - 40 mm.
5. For the sake of efficient air circulation the unit has to be located according to the dimensions on the Fig. 2 and
the design of the cabinet must enable air flow into its bottom part. A gap of at least 50 mm should be below the
heating plate and at least 50 mm behind the rear wall of the box.t
Fig. 1
Fig. 2
EN
55
IDV2560wh | IDV2660n
Summary of Contents for IDV 2660n
Page 2: ...ID D c P k O T D P P N T T Č I Ř S O P C V v ř 1 N t 2 J 3 V n s j P p P T s p P m ...
Page 61: ......
Page 62: ......
Page 63: ......
