160
EN
MNV3660
Connection to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the appliance.
We recommend using a separate outlet with a 10A circuit breaker.
• Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords. There is a risk of overheating.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
• Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is connected to
the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad
protective connection.
Connection of the water supply
• Before connecting the inlet hose to the water supply,
make sure that the water pressure is in the range of 0.04 to
1.00 MPa. When water pressure is higher, you must install
a pressure reducing valve.
• Connect the inlet hose to the tap with 3/4“ thread (Pic.
17). Make sure that the inlet hose is not bent, crushed or
entangled.
• When replacing the appliance always use
a new inlet hose
!
• If the water pipes are new or they have not been used for
a longer period of time, run off a sufficient amount of water
before connecting the inlet hose to rinse the pipes and wash
away any impurities.
• If these safety instructions are not observed, it may lead to
blockage and damage to the appliance.
Pic. 16
Check how
straight it is using
a spirit level.
Check how straight it is using a spirit level.
Pic. 17
Summary of Contents for MNV3660
