53
EN
OPI4060bc
Cleaning and replacement of filters
Metal fat filters
When the appliance is in common use, the metal fat filters should be
checked or cleaned every month. In case of more frequent frying or
deep frying, shorten this interval.
Do not use the appliance without the metal fat filters properly
installed!
1. Remove the metal filters as shown in Fig. 1.
2. We recommend to soak the metal filters in warm water with a
detergent, then to clean with a soft brush, rinse with clean water
and allow to dry. The filters are also dishwasher safe using a
program
below 60 °C
. In this case, it is necessary to avoid the use
of aggressive detergents –the aluminum filters can blacken under
the influence of the chemical reaction.
3. Reinstall dried out filters.
Carbon filter
This filter is only used for the recirculation mode.
The filter contains an active carbon absorbing the smell being discharged. The active carbon will be saturated after
some time, hence the absorption capacity will be shortened. This filter cannot be washed or cleaned in any other way.
When the appliance is in common use, the carbon filter should be replaced every 2-3 months. In case of more frequent
frying or deep frying, shorten this interval.
1. Remove the metal filters as shown in Fig. 1.
2. The carbon filters are situated on both sides of the motor. Turn the filters, until they are secured (see Fig. 2).
3. To replace the carbon filter, proceed in reverse order.
CAUTION!
Carbon filters are not included in the package.
Fig. 2
Opened
Closed
Opened
Closed
Fig. 1
Summary of Contents for OPI4060bc
Page 2: ...2 OPI4060bc CZ ...
