Concept2 OPK 5760N Operating Manual Download

Page: 29 / 36

OPK 5760N | OPK 5760WH | OPK 5790N

OPK5760, OPK5790

IMPORTANT NOTICES:

Delivery

• Check the package and unit immediately after delivery for any damage that may have occurred during

shipping.

•  If the unit is damaged, do not operate it. Contact the supplier as soon as possible.
•  Remove all the covering and marketing materials from the unit before the first use.
•  Dispose of the packaging material properly.

Installation

•  The unit is designed to be mounted on the wall.
•  Follow the instructions for the appliance connection and installation.
•  The unit has to be disconnected from the power socket during installation.
•  Before connecting the appliance, ensure that your local connection is earthed and compliant with all applicable

regulations.

• Make sure the mains voltage and current protection correspond to the values on the rating plate. Use earthed

wall outlets only.

•  After installation of the unit, the plug or circuit breaker shall be freely accessible.
•  Only an authorized technician may install and connect your appliance.
•  Improper connection and/or incompetent installation may result in injury or death.
•  The manufacturer takes no responsibility for any damage incurred due to improper installation or use.

Normal operation

• Use the unit only as described in this operating manual.
• Use the unit only in a household, solely for the purpose of absorbing vapor created during cooking, or the re-

circulation and absorption of odors created during cooking.

• Install the unit at least 450 mm above the electric stove (or hotplate), and 550 mm at minimum above a gas

stove (or gas hotplate).

• Never operate the appliance with wet hands.
• In case of any failure, and before maintenance and cleaning, turn off the product and disconnect the plug from

the mains outlet, or switch off the circuit breaker.

•  Never pull the cord to disconnect the plug from the wall outlet; hold the plug instead.
•  Check the appliance and power cord for damage regularly. Never switch on a damaged appliance.
•  Do not immerse the power cord, plug, or appliance in water or any other liquid.
•  Make sure that all controls are in the OFF position when the appliance is not in use.
•  Do not handle open flame under the unit (e.g. flambee)! If you remove a cooking vessel from a gas stove, turn

down the flame to the minimum, or turn it off!

Make sure the diameter of the burner of gas stove or gas hotplate corresponds with the cookware used. When

using smaller than recommended vessels, the flames could touch the sides, and plastic handles could be
scorched – risk of fire!

• When you deep-fry or fry food, keep it under continuous supervision. When oil is overheated, there is a risk of

fire!

• Keep the intervals for replacement and cleaning of the filters (every 2 months at minimum). If these instructions

are not followed, there is a risk of fire due to fat sediments in the filters!

• For the ventilation ducts, all the applicable standards and regulations shall be observed.
• The diameter of the duct pipeline for the airing mode should be approximately the same as the diameter of

OPK5760, OPK5790

PRODUCT DESCRIPTION

A Body of the unit
B Lower chimney cover
C Upper chimney cover
D Filter casing
E Wall holder of the upper chimney cover
F Upper cover

Accessories

1. Backﬂ ow valve

output pipe of the absorber.

• The air shall not be ventilated through a chimney used for combustion gases, or in a shaft used for airing rooms

where combustion chambers are installed.

• During operation in the airing mode, a sufficient opening for inlet air shall be created; its size shall be

approximately the same as or bigger than that of the hole for ventilated air.

• During the simultaneous operation of the unit in airing mode and the stove, the underpressure in the room shall

not exceed 4 Pa (0.04 mbar).