EN
31
OPK4460, OPK4490, OPO5590
b) Island type (model OPO 5590)
1. Mark the centre of the hotplate on the ceiling above.
2. Drill holes, fix the ceiling holder using supplied wall plugs and screws (Fig. 7).
3. For the airing mode mount backflow valve on the output hole, and connect the output hole of the fan with the
hole in the wall using flexible pipe. If need be use the adapter (150/120 mm).
Note:
Flexible pipe and diameter adapter are not supplied.
4. Mount the upper chimney cover on the ceiling holder (Fig. 8), and fix it using the screws (B).
5. Mount the lower chimney cover on the ceiling holder (Fig. 9 and 10), shift up and fix to the body using screws
(C). Keep the minimum required height above the hotplate (650 mm for electric, and 700 mm for gas hotplates,
Fig. 6).
6. Open the switch box and connect the control cable. Connect all other possible connectors.
7. Plug the supply cable in the wall outlet and shift the lower chimney cover down.
Fig. 3
Fig. 4
Fig. 5
Fig. 7
Fig. 8
Fig. 9
Fig. 10
