USER'S MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene
reasons.
Ventilation mode
The extracted air is discharged through the flexible outlet duct to the ventilation shaft out of the room. If the
appliance is equipped with a carbon filter, remove it (see chapter Cleaning and maintenance).
1. Push button (5) to switch on the appliance.
2. Using buttons (2) and (4) select the required value of the extracted air exhaust output.
3. The display (3) shows the output value (1-3).
4. Push button (5) twice to switch the appliance off.
Recirculation mode
If there is no possibility of discharging the extracted air out of the room, you can use the recirculation mode.
In this case, the extracted air is filtered through the metal fat filters and the carbon filter. An active carbon
in this filter absorbs the smell. Air, free from the smell, flows back into the room through openings situated in
the upper chimney cover. When the recirculation mode is used, it is necessary to purchase and install the
appropriate carbon filters (see chapter Cleaning and maintenance).
1. Push button (5) to switch on the appliance.
2. Using buttons (2) and (4) select the required value of the extracted air exhaust output.
3. The display (3) shows the output value (1-3).
4. Push button (5) twice to switch the appliance off.
Note:
When the recirculation mode is used (carbon filter installed), the extracted air output can drop.
CLEANING AND MAINTENANCE
• Disconnect the power cord from the wall outlet or switch off the circuit breaker of the appliance before
cleaning and maintenance.
• To clean the appliance outside, use a damp cloth, a soft brush or a fine sponge, and then wipe it dry.
• Do not use coarse abrasive cleaning agents or sharp metal scrapers for cleaning of the appliance as this
could result in surface scoring.
• Do not use steam jets to clean the appliance!
• Never leave aggressive or acidic substances (lemon juice, vinegar) on enamelled or stainless parts of the
appliance.
Cleaning and replacement of filters
Metal fat filters
When the appliance is in common use, the metal fat filters should be checked or cleaned every month.
In case of more frequent frying or deep frying, shorten this interval.
Do not use the appliance without the metal fat filters properly installed!
65
EN
OPK4590bc
