58
EN
OPK4960ds
EN
Night light mode
1.
Night light mode can be activated on the hood. If the light sensor (10) detects a lack of light in the room, it dimly
lights up the hood light automatically. As soon as enough daylight gets into the kitchen, night light mode is
automatically switched off.
2.
To activate the night light mode, press the button for setting time and automatic ventilation (1) and the lighting On/
Off button (9) simultaneously for 2 seconds.
3.
To switch off the night light mode, press the button for setting time and automatic ventilation (1) and the lighting
On/Off button (9) simultaneously for 2 seconds.
Recirculation mode
If there is no possibility of discharging the extracted air out of the room, you can use the recirculation mode. In this
case, the extracted air is filtered
through the metal fat filters and the carbon filter
An active carbon in this filter
absorbs the smell. Air, free from the smell, flows back into the room through openings situated in the upper chimney
cover. When the recirculation mode is used,
it is necessary to purchase and install
the appropriate carbon filters
(see chapter Cleaning and Maintenance).
Note:
When the recirculation mode is used (carbon filter installed), the extracted air output can drop.
CLEANING AND MAINTENANCE
1. Disconnect the power cord from the wall outlet or switch off the circuit breaker of the appliance before cleaning
and maintenance.
2. To clean the appliance outside, use a damp cloth, a soft brush or a fine sponge, and then wipe it dry.
3. Do not use coarse abrasive cleaning agents or sharp metal scrapers for cleaning of the appliance as this could result
in surface scoring.
4. Do not use steam jets to clean the appliance!
5. Never leave aggressive or acidic substances (lemon juice, vinegar) on enamelled or stainless parts of the appliance.
Cleaning and replacement of filters
Metal fat filters
When the appliance is in common use, the metal fat filters should be
checked or cleaned every month. In case of more frequent frying or
deep frying, shorten this interval.
Do not use the appliance without the metal fat filters properly
installed!
1. Remove the metal filters as shown in Fig. 1.
2. We recommend to soak the metal filters in warm water with a
detergent, then to clean with a soft brush, rinse with clean water
and allow to dry. The filters are also dishwasher safe using a
program
below 60 °C
. In this case, it is necessary to avoid the use
of aggressive detergents –the aluminum filters can blacken under
the influence of the chemical reaction.
3. Reinstall dried out filters.
Fig. 1
Summary of Contents for OPK4960ds
Page 2: ...2 OPK4960ds CZ CZ ...
Page 15: ......
