EN
32
OPO5790
Fig. 3
UNIT INSTALLATION
•
Only authorized personnel can install the power connection!
• Only the customer, not the manufacturer, is responsible for installation. Defects caused
by incorrect installation are not covered by the warranty.
• Remove all the covering and marketing materials from the unit before the fi rst use.
• We recommend that you let a specialized company perform the installation.
• The manufacturer bears no responsibility for damage caused to people, animals or
objects as a result of incorrect installation.
Follow the installation instructions:
1. Mark the center of the hotplate on the ceiling above.
2. Mark and drill holes for the ceiling holder. Fix the ceiling holder using the supplied
wall plugs and screws (D) - Fig. 7.
3. For the airing mode, mount the backfl ow valve on the output hole, and connect the
output hole of the fan to the hole in the ceiling using a fl exible pipe. If necessary, use
the adapter (150/120 mm).
Note:
Flexible piping and diameter adapter are not supplied.
4. Mount the upper chimney cover on the ceiling holder (Fig. 8), and fi x it using the
screws (F).
5. Mount the lower chimney cover on the ceiling holder (Fig. 9), shift up and fi x to the
body (Fig. 7)using screws (E). Keep the minimum required height above the hotplate
(450 mm for electric, and 550 mm for gas hotplates, Fig. 6).
Fig. 6
b) Carbon filter (must be purchased)
This filter is used only in the re-circulation mode.
The filter contains active carbon that absorbs the ventilated odors. After a while the active carbon is saturated, and
loses its absorption ability. The filter can‘t be washed or otherwise cleaned.
Under normal use, the carbon filter should be replaced every 2 months. In case of more frequent frying or deep
frying, shorten the interval.
1. Open the filter casing (Fig. 1).
2. Remove the metal filter (Fig. 2), and remove the carbon filter from it.
3. Mount a new carbon filter on the metal one (Fig. 3), and put the set back.
4. Close the filter casing.
5. Replace the filters on both sides of the unit following the same steps.
