56
EN
OPP1250wh
USER MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene reasons.
Ventilation mode
The extracted air is discharged through the flexible outlet duct to the ventilation shaft out of the room. If the appliance
is equipped with a carbon filter,
remove it
(see chapter Cleaning and Maintenance).
1. Use the button (2) to select the desired level of the extracted air output.
2. Press the button (1) to turn the ventilation off.
Recirculation mode
If there is no possibility of discharging the extracted air out of the room, you can use the recirculation mode. In this
case, the extracted air is filtered
through the metal filters and the carbon filter
. An active carbon in this filter
absorbs the smell. Air, free from odours, flows back into the room through openings situated in the front cover of the
appliance's body. When the recirculation mode is used,
it is necessary to purchase and install the appropriate
carbon filters
(see chapter Cleaning and Maintenance).
1. Use the button (2) to select the desired level of the extracted air output.
2. Press the button (1) to turn the ventilation off.
Note:
When the recirculation mode is used (carbon filter installed), the extracted air output can drop.
Turning the lights on/off
•
Press the button (3) to turn the lightning on/off.
CLEANING AND MAINTENANCE
•
Disconnect the power cord from the wall outlet or switch off the circuit breaker of the appliance before cleaning
and maintenance.
•
To clean the appliance outside, use a damp cloth, a soft brush or a fine sponge, and then wipe it dry.
•
Do not use coarse abrasive cleaning agents or sharp metal scrapers for cleaning of the appliance as this could result
in surface scoring.
•
Do not use steam jets to clean the appliance!
•
Never leave aggressive or acidic substances (lemon juice, vinegar) on enamelled or stainless parts of the appliance.
