EN
26
OPV3260
b) Carbon filters (must be purchased)
These filters are used only in the re-circulation mode.
The filters contain active carbon that absorbs the ventilated odors. After a while the active carbon is saturated, and
loses its absorption ability. These filters can‘t be washed or otherwise cleaned.
Under normal use, the carbon filters should be replaced every 2 months. In case of more frequent frying or deep
frying, shorten the interval.
1. Remove the metal filters (Fig. 1), and remove the carbon filters from them.
2. Mount new carbon filters on the metal ones (Fig. 2), and put the set back.
Fig. 2
UNIT INSTALLATION
•
Only authorized personnel can install the power connection!
• Only the customer is responsible for installation in situ. Defects
caused by incorrect installation are not covered by the warranty.
• Remove all the covering and marketing materials from the unit before
the first use.
• We recommend that you let a specialized company perform the
installation.
• The manufacturer bears no responsibility for damage caused to
people, animals or objects as a result of incorrect installation.
Follow the installation instructions:
1. Remove both fat (or carbon) filters.
2. Put the unit on the lower edge of the upper cupboard of the kitchen
set. Check the minimum required height according to Fig. 3 (650
mm for electric, and 750 mm for gas hotplates).
3. You will see the fixing holes through the lower orifice of the unit.
Mark the positions on the bottom side of the cupboard.
4. Mark the position and diameter of the hole for the output piping.
5. Drill a hole for the output piping.
6. Fix the unit to the bottom side of the cupboard using the supplied
screws (Fig. 4).
Fig. 3
