49
EN
OPV3760bc
33
EN
OPV3260
EN
26
OPV3260
b) Carbon filters (must be purchased)
These filters are used only in the re-circulation mode.
The filters contain active carbon that absorbs the ventilated odors. After a while the active carbon is saturated, and
loses its absorption ability. These filters can‘t be washed or otherwise cleaned.
Under normal use, the carbon filters should be replaced every 2 months. In case of more frequent frying or deep
frying, shorten the interval.
1.
Remove the metal filters (Fig. 1).
2. Install new carbon filters on the engine (Fig. 2 and Fig.3).
3. Replace the metal grease filters.
UNIT INSTALLATION
•
Only authorized personnel can install the power connection!
• Only the customer is responsible for installation in situ. Defects
caused by incorrect installation are not covered by the warranty.
• Remove all the covering and marketing materials from the unit before
the first use.
• We recommend that you let a specialized company perform the
installation.
• The manufacturer bears no responsibility for damage caused to
people, animals or objects as a result of incorrect installation.
Follow the installation instructions:
1.
Remove both fat (or carbon) filters.
2.
Put the unit on the lower edge of the upper cupboard of the kitchen
set. Check the minimum required height according to Fig. 3 (
5
50
mm for electric, and
6
50 mm for gas hotplates).
3.
You will see the fixing holes through the lower orifice of the unit.
Mark the positions on the bottom side of the cupboard.
4.
Mark the position and diameter of the hole for the output piping.
5.
Drill a hole for the output piping.
6.
Fix the unit to the bottom side of the cupboard using the supplied
screws (Fig. 4).
Fig. 3
34
EN
OPV3260
EN
27
OPV3260
Fig. 4
Fig. 5
Fig. 6
7. For the airing mode, mount the backflow valve on the output hole, and connect the output hole of the fan to
the hole in the wall using flexible pipe (Fig. 5).
For the re-circulation mode fix only the flexible pipe to the output hole, and leave the outlet in the room
(Fig. 6).
Note:
Flexible pipe is not supplied.
8. Mount the fat (or carbon) filter.
9. Plug the supply cable into the wall outlet.
Removal
Before removal, disconnect the power cable from the wall outlet, and follow the reverse steps to remove individual
parts of the unit.
55
0 - 6
50 m
m
Summary of Contents for OPV3760bc
