89
OZ4022
CZ
USER‘S MANUAL
Before first use
After connecting the appliance to the mains or after a power failure, there is a display test, which lasts for 10 seconds.
At the same time the cooling fan gets activated. It is not possible to use the appliance during this time.
First cleaning and heating
1. Remove all the packaging and marketing materials before first use.
2. Peel the anti-slip mat off from the bottom of the drawer.
3. Remove the drawer, if it is possible.
4. Wipe the visible part (internal and external) with a damp cloth and then dry it with a soft cloth.
5. Stick the anti-slip mat back on the bottom of the drawer.
Before first use, power up the empty drawer for no less than two (2) hours.
Note:
1. The appliance is equipped with a „Push to open“ closing mechanism.
2. The appliance is equipped with a contact switch ensuring the appliance only turns on after the warming drawer
is closed.
3. During the initial operation the appliance may emit a slight odour. This is because some of the metal
components inside the appliance are equipped with a protective coating. The odour will disappear after a short
time.
4. Make sure that during this process the room is well ventilated.
Specifications
1. After connecting the appliance to the mains you will hear an audible signal. Open the drawer and the display shows „0“.
2. When setting the time, this operation can “time out” if there is no activity within 3 minutes, the appliance will return
to standby mode.
3. After pressing any button, you will hear an audible signal.
4. After the drawer has warmed up you will hear an audible signal three times.
Setting the functions
1. Press a button (1), (2) or (3) while the appliance is in an idle mode (standby mode) to select a desired function.
2. The display shows the preset temperature of the selected function (40°C or 60°C).
3. Press the button „+“ or „-“ to set the desired temperature.
4. Hold the button (5) and press the „+“ or „-“ to set the desired time.
5. Press the button (8) to confirm the settings.
6. Close the drawer. The appliance will operate according to the settings.
Note:
1. When setting the parameters, you can change the function by pressing the desired button (1), (2) or (3).
2. You can press the button (7) to cancel any selected setting before closing the drawer. The appliance will return to
standby mode.
3. During the heating process you can change the parameter settings for the actual heating. Open the drawer and
select the parameter you want to change by pressing the button (4) or (5). Press the button „+“ or „-“ to adjust
the selected temperature or the time. Press the button (8) to confirm the newly set parameters.
4. Close the drawer to continue with the heating process.
5. Press the button (7) to cancel the heating process with the newly set parameters.
6. After pressing button (8) the function cannot be changed. You can only change the temperature and time.
7. To change the function, you must first press button (7). Then press the button (1), (2) or (3) to select the desired
function and the appropriate parameters for heating.
EN
Summary of Contents for OZ 4022
