EN
14
RK7020
• Take precautions to avoid scalding with hot water while handling the appliance.
• Do not use abrasive or chemically aggressive substances to clean the appliance.
• Do not use the appliance if it does not operate properly, if it has been dropped, damaged, or immersed into liquid.
Take the appliance to an authorised service centre for testing and repair.
• Never use the appliance with a damaged power cord or plug; contact an authorised service centre immediately to
have the defective components repaired or replaced.
•
Do not immerse the power cord, the plug, or the appliance in water or other liquids.
• Do not attempt to repair the appliance. Contact an authorised service centre.
Failure to observe the manufacturer’s instructions invalidates the warranty.
DESCRIPTION
1. Outer part of the lid
2. Kettle lid
3. Power cord
4. Power socket
5. Body
1
2
5
3
4
OPERATING INSTRUCTIONS
1. First unscrew the outer part of the kettle lid (1), then the lid itself (2).
2. Fill the kettle with water (observe the maximum recommended level indicated with a mark inside the body).
3. Screw the lid (2) in place. While heating water, do not touch the outer part of the lid (1) – the appliance uses a relief
valve in the lid (2) to avoid pressure build-up inside the kettle during operation.
4. Connect the power cable (3) to the kettle socket (4).
5. Connect the plug to the power supply socket of the vehicle. Operation of the kettle is indicated by the red light.
6. Once the water starts boiling, the operating thermostat switches the appliance off automatically (the red light goes
dark). Pull the plug from the vehicle power socket and unscrew the lid (2) carefully. Caution: The kettle is designed as
a thermal insulation bottle: although the body feels cold, there is hot water inside — scalding risk!
The outer part of the lid (1) only serves as a cover and a pouring cup. The kettle must only be operated only with the lid
(2), i.e. without the outer part (1). Never switch the kettle on unless there is water inside. Operating the kettle without
water may cause damage to the product.
Once the water has boiled, pull the plug from the vehicle power socket.
