Mincer
Important:
• DO NOT TRY TO ATTEMP TO USE THIS FUNCTION TOGETHER WITH BLENDING OR
MIXING.
1. Cut all foods into pieces (Sinewless, boneless and fatless beef or pork is recommended,
approximately size :20 mm x 20 mm x 60 mm) so that they fi t easily into the hopper
opening.
The ingredients would avoid bone or hard stuff with it, hard stuff or bone would cause
the motor seized. If the engine is seized, please stop the unit and disassemble the mincer
assembly to take out the bone or hard stuff , if the motor is stopped automatically, after
the motor is cooled down, the function would restore.
2. Assemble the mincer as below description, turn on the unit at speed 6;
3. Feed foods into the tray (16). Use for it only the food pusher (15).
4. After using, turn the switch (3) to “0” and unplug it from the power supply.
5. Use less than 6 minutes continuously at a time.
How to assemble the mince
• Remove the front cover. (Fig 1)
• align and turn the chute in anti-clockwise direction , until the mincing tube is in place
fi rmly. (Fig 2)
• Put a meat container below the chute.
• Set the speed control to position 6. Then place the desired foodstuff into the tray and use
the pusher to push the food into chute. (Fig3)
• After use, switch off the appliance and unplug it.
• Press the mincer locking button, turn the mincer clockwise and remove the mincer as-
sembly. (Fig4)
• Cover the front cover. (Fig5)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
34
RM4420 RM4421
EN
Summary of Contents for RM-4420
