Grater
IMPORTaNT:
•
DO NOT TRY TO ATTEMP TO USE THIS FUNCTION TOGETHER WITH
BLENDING OR MIXING.
1. Cut all foods into pieces approximately size :20×20×60 mm so that
they fit easily into the hopper opening.
The ingredients would avoid bone or hard stuff with it, the hard part
would cause the motor seized. If the engine is seized, please stop the
unit and disassemble the grater assembly. If the motor is stopped
automatically, after the motor is cooled down, the function would
restore.
2. Assemble the grater as below description, turn on the unit at speed
6;
3. Feed foods into the tray. Use for it only the food pusher.
4. After using, turn the switch (3) to “0” and unplug it from the power
supply.
5. Use less than 6 minutes continuously at a time.
How to assemble the grater
•
Remove the front cover. (fig. 1)
•
Align and turn the chute in anti-clockwise direction , until the grate
tube is in place firmly. (fig. 2)
•
Put a container below the chute.
•
Set the speed control to position 6. Then place the desired foodstuff
into the tray and use the pusher to push the food into chute. (fig. 3)
•
After use, switch off the appliance and unplug it.
•
Press the grater locking button, turn the grater clockwise and remove
the grater assembly. (fig. 4)
•
Cover the front cover. (fig. 5)
1. Pusher
2. Body of the grating
3. Vegetable slicer
4. Coarse grater
5. Fine grater
6. Potato grater
1
3
4
5
6
2
fig. 1
fig. 2
fig. 3
fig. 4
fig. 5
EN
48
RM 5000
