ENGLISH
14
5.2
Connect automatically using the WPS (Virtual) Push Button
The Conceptronic 150
N
Wireless USB Adapter supports WPS (Wi-Fi Protected Setup). WPS is a standard to
easily secure your wireless network. With WPS you can protect your wireless network with just a few easy
steps without knowledge of different encryption methods.
Note:
To use the WPS option of the 150
N
Wireless USB Adapter your router or access point also needs to
support WPS.
-
Select the page ”
WPS
” in the wireless utility.
-
Start WPS configuration on your router or access point by either pressing the WPS button on the device
or the soft button in the web interface of the device.
-
Press the WPS button on the 150
N
Wireless USB Adapter (refer to
chapter 2
to see where the WPS
button is located) or use the virtual WPS Push Button (named “
PBC
”) in the wireless utility.
The wireless utility will be triggered by the (virtual) WPS button and will try to connect to your wireless
network. If the wireless utility main window is shown on your screen, you can see the WPS activity at the
bottom of the window:
When the WPS Push Button authentication is completed successfully, the message “
Get WPS profile
successfully
” will be shown shortly.
-
Select the newly created WPS profile from the ‘
WPS Profile List
’ and click on “
Connect
” to establish
the wireless connection.
You are now connected to your wireless network. The wireless utility will indicate the signal strength in
your system tray:
