English
Conceptronic EMRICK03G
Installation & usage
Turn Off the power to your computer.
Unplug the power cord and remove your computer’s cover.
Remove the slot bracket from an available PCIe slot.
To install the card, carefully align the card’s bus connector with the
selected PCIe slot on the motherboard. Push the board down firmly.
Replace the slot bracket’s holding screw to secure the card.
Replace the computer cover and reconnect the power cord.
Your computer will show the “New Hardware Wizard” on your screen.
You can ignore this “New Hardware Wizard” by clicking “Cancel”.
Insert the CD-ROM in the optical drive of your computer. The
AutoPlay option will be shown automatically. Click on “Run Autorun.exe”
to start the autorun menu.
Select “Install Drivers” and follow the onscreen instructions to install
the required driversfor the serial PCIe card.
When the driver installation is complete, restart your computer to
ensure the drivers are correctly loaded.
Mode switching instruction:
Middle: No boot
Left: ACHI MODE
Right: IDE MODE
