ENGLISH
7
3. Hardware Installation CHD3UL
3.1
Assembling the CHD3UL (When no hard disk is installed yet)
If you bought the CHD3UL with a hard disk pre-installed, you can skip this step and
continue to step 3.2
a.
Remove the 2 screws at the back of the CHD3UL and remove the back plate.
b.
Gently slide the hard disk tray out of the housing.
c.
Connect the power and IDE cable to the hard disk and place the hard disk in the tray.
d.
Turn over the tray and use the 4 supplied screws to fasten the hard disk to the tray.
e.
Slide back the tray in the housing, attach the back plate to the backside of the tray
and use the 2 screws to fasten the back plate.
Note:
You need to set your hard disk to ‘Master’ or ‘Single’, depending on the
type of hard disk you are using. How to make this setting is indicated on
your hard disk itself or in its manual.