6
1.3
Staff obligation
Prior to commencing work, all individuals who are commissioned to work on the system or carry out
such work independently undertake to:
read the safety section and the warnings in these operating instructions and confirm by their
signature that they have understood them.
observe the basic health and safety and accident prevention regulations.
When operating the system, the safety instructions must be strictly observed.
1.4
Staff training
Only trained and instructed personnel may work on the system.
The assembly, commissioning, operating, set-up, equipment, maintenance and servicing
responsibilities of the personnel must be clearly defined.
Staff members who have not as yet been trained may only work on the system under the
supervision of an experienced co-worker.
1.5
Intended use
The system may only be used for the desalination of drinking water, well water or surface water
which is free from particles and metal ions. The restrictions regarding the chemical analysis of the
feed water, pressure, temperature and flow rate specified in the technical data apply.
Intended use also includes
observance of all instructions in the operating instructions and
compliance with inspection and maintenance intervals.
The restrictions specified in the technical data apply with regard to the chemical analysis of the feed
water, pressure, temperature and flow rate.
The following are also deemed non-intended use: utilisation as filter (mechanical filtration without
regeneration with brine), storage tank (after removal of the ion exchanger material), pressure
reservoir. Furthermore, hot water may not be fed into the system.
1.6
Hazards in handling the system
The system has been designed and manufactured in accordance with the state of the art
and the recognised safety regulations.
The system must be installed in such a way that the operating and control elements are
easily accessible at all times. The floor, ceiling and walls must be level and clean.
Nevertheless, its use may pose a health hazard to the user or third parties or put their lives at
risk, or cause damage to the system itself or other property. The system is only to be used for
its intended purpose (see 1.5) and in a safe condition.
The following residual hazards exist:
General safety instructions
Summary of Contents for CONDAIR SOFT
