22
The installation site of the steam generator depends largely on the location of the steam distributor
(see chapter .). To
ensure
proper functioning
of the steam generator and to
obtain an optimal
efficiency
, the following points must be considered and observed when choosing the location for
the steam generator:
– Install the steam generator so that the
length of the steam
hose is kept as short as possible
(
max. 4 m
) and that the
minimum bend radius (R= 300 mm)
and
up-slope (20 %)
or
down-
slope (5 %)
of the steam hose is observed (see chapter ..).
– The steam generators Condair CP3 D are designed for wall-mounting. Make sure that the construc-
tion (wall, pillar, floor-mounted console, etc.) to which the steam generators are to be mounted,
offers a
sufficiently high load-bearing capacity
(take notice of the weight information found in
the dimension sand weights table above), and is suitable for the installation.
– The back panel of the Condair CP3 D is retaining heat during operation (max. surface temperature
of the metal housing approx. 0 - 0 °C). Make sure, therefore, that the construction (wall, pillar,
etc.) to which the units are to be mounted, does not consist of heat-sensitive material.
– Install the steam generator in such a manner that it is
freely accessible
with sufficient space
available for maintenance purposes (refer to the above illustration for minimum distances).
– The Condair CP3 D is protected according to
IP20
. Make sure the units are installed in a drip-proof
location and the admissible ambient conditions are complied with.
– The steam generator Condair CP3 D may only be installed in rooms with a floor drain.
CAUTION!
If for some reason the Condair CP3 D must be installed in a location without floor
drain, it is mandatory to provide a leakage monitoring device to safely interrupt
the water supply in case of leakage.
– When fixing the Condair CP3 D use
only the fixing materials supplied with the unit
. If fixing
with the materials supplied is not possible in your particular case, select a method of fixing that
is of similar stability.