23
d
e
b
c
a
A
B
B
5.3.2
Mounting the unit
Procedure
1. Mark the attachment point “A” on the wall.
2. Drill hole for attachment point “A” (diameter: mm, depth: 0 mm).
3. Insert the supplied plastic plug, and tighten the screw until the distance between the wall and
the screw head is mm.
. Unlock the two screws fixing the front panel to the unit, then remove the front panel.
. Hang up the unit onto the screw and adjust it horizontally and vertically using a spirit level. Then,
mark the fixing points “B”.
. Drill the holes for the fixing points “B” (diameter: mm, depth: 0 mm).
. Insert the supplied plastic plugs, and tighten the screws until the distance between the wall and
the screw head is mm.
. Hang the unit up onto the screws. Before tightening the screws, readjust the unit with the spirit
level.
. Reattach the front panel and secure it with the two screws.
Dimension
Housing size
small
large
a
228 mm
284 mm
b
51 mm
51 mm
c
500 mm
545 mm
d
90 mm
144 mm
e
180 mm
216 mm
