2
Water supply
The water supply is to be carried out according to the figure found in chapter ..1 and the applicable
local regulations for water installations. The indicated connection specifications must be observed.
– The installation of the
filter valve
(accessory “Z21”, alternatively a shut-off valve and a µm
water filter can be used) should be made as close as possible to the steam generator.
– Admissible mains pressure
1.0 to 10.0 bar (hammer-free system)
For mains pressures >10 bar, the connection must be made via a pressure reducing valve (adjusted
to 1.0 bar). For mains pressures <1.0 bar please contact your Condair supplier.
–
Notes on water quality
:
– For the water supply of the Condair CP3 D, use exclusively
untreated drinking water
.
– The use of
additives
such as corrosion inhibitors, disinfectants, etc. is
not allowed
, since
these additives may endanger health and affect proper operation.
– If the Condair CP3 D shall be operated with softened or partly softened water, please contact
your Condair supplier.
– The connection material must be
pressure-proof
and
certified for use in drinking water systems
.
–
Important!
Before connecting the water line
, the line should be well flushed out
.
CAUTION!
The thread at the unit connection is made of plastic. To avoid overtightening, the
union nut of the water pipe must be
tightened by hand
only.
Water drain
The water drain is to be carried out according to the figure found in chapter ..1 and the applicable
local regulations for water installations. The indicated connection specifications must be observed.
– Make sure that the drain pipe is correctly fixed and easily accessible for inspections and cleaning
purposes.
– The draining temperature is:
80…90 °C
(approx. 0...0 °C with activated drain water cooling).
Use temperature-resistant installation materials only!
5.5.2
Notes on water installation