18
19
User manual
Thermal imager
IR-CAM
2 CONDTROL
User manual
Thermal imager
IR-CAM
2 CONDTROL
uTIlIzaTION
expired tools, accessories and package should be passed for waste recycle. please send the
product to the following address for proper recycle:
condtrol Gmbh
wasserburger strasse 9
84427 sankt wolfgang
Germany
do not throw the product in municipal waste!
According to European directive 2002/96/еC expired measuring tools and their components
must be collected separately and submitted to environmentally friendly recycle of wastes.
warraNTy
All condtrol Gmbh products go through post-production control and are governed by the
following warranty terms. the buyer’s right to claim about defects and general provisions of
the current legislation do not expire.
1) CONDTROL GmbH agrees to eliminate all defects in the product, discovered during the
warranty period, that represent the defect in material or workmanship in full volume and at
its own expense.
2) The warranty period is 12 months and starts from the date of purchase by the end
consumer (see the original supporting document).
3) The Warranty does cover defects resulting from wear and tear or improper use,
malfunction of the product caused by failure to observe the instructions of this user manual,
untimely maintenance and service and insufficient care, the use of non-original accessories
and spare parts. Modifications in design of the product relieves the seller from responsibility
for warranty works. the warranty does not cover cosmetic damage, that doesn’t hinder
normal operation of the product.
4) CONDTROL GmbH reserves the right to decide on replacement or repair of the device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by CONDTROl GmbH warranty period is not renewed or
extended.
7) CONDTROL GmbH is not liable for loss of profit or inconvenience associated with a
defect of the device, the rental cost of alternative equipment for the period of repair.
this warranty applies to German law except provision of the united nations convention on
contracts for the international sale of goods (CISG).
in warranty case please return the product to retail seller or send it with defect description to
the following address:
condtrol Gmbh
wasserburger strasse 9
84427 sankt wolfgang
Germany
Summary of Contents for IR-CAM 2
