Operating Instructions
LASSTEC
Weighing System 0521
BAL0521-0001-EN
www.conductix.com
translated document
page 108 of 123
6.2.8.4
TCP/IP server configuration
When the config TCP/IP button is pressed on the user configuration page, the following page will appear:
This page allows to set the IP address of the server (not of the HMI) and simulate a data send.
Set the new server IP:
The way to set the IP address of the server is to enter the four parameters of the IP address separately, then confirm by click on SET
button.
To enter the IP-Address (see chapter 7.3.3 How to type the IP-Address).
Simulation:
If you press with button, the HMI will send test data to the server. This function will be used, if no test weight is available.
Navigation:
Button
Action
1_1
Exit the current page and go on HMI IP configuration page
1_2
Ping request (Enable if Unlock)
3_1
Confirm and set the new IP address (Enable if Unlock)
3_3
Send data to the server (Enable if Unlock)
3_4
Exit the current page and go on configuration page
