Operating Instructions
LASSTEC
Weighing System 0521
BAL0521-0001-EN
www.conductix.com
translated document
page 113 of 123
6.3
Procedures
This chapter describes the procedures in order to configure the HMI.
WARNING!
All these procedures must be made when the crane is not in use, in order to not
disturb the driver and operations, unless otherwise specified.
6.3.1
How to type a password
If you try to access to User config page or to change the current password, you have to enter a password, following an example of how
tipping a password:
For example, type “LASSTEC” as password:
1.
Select the text box with navigation keys (UP or DOWN).
2.
Edit the text box by pressing the PUSH button.
3.
Press the UP key (once for choose the next character; keep pressed for fast change of character), press DOWN key for choose
previous character.
4.
Once you have the “l” character press the RIGHT key once to move the cursor by one character on the right.
5.
Then proceed the same way for the next characters
6.
Once the “c” character is entered, press the PUSH key to validate the password.
7.
The password is now display with “*” for each entered character and ready for validation.
6.3.2
How to set the date and time
The date and time setting of the IHM is related to the date and time of the datalogging, make sure to set a correct date and time in order
to avoid a wrong datalogging.
To set the date and time:
1.
From the home page of the HMI, press the Config button.
2.
From the configuration page, press the user Config button.
3.
Enter your password (see the password chapter 6.3.1).
4.
From the user config page, press the set date and time button.
5.
From the set date and time page, select the year by pressing the UP or DOWN key.
6.
Press the PUSH key to edit the year.
7.
Now the keyboard is displayed, the keys UP/DOWN/LEFT/RIGHT must be pressed to get to the requested keyboard button.
8.
At first the keyboard button CLEAR or BACK must be selected and confirmed with the PUSH key.
9.
Enter the year number between 2014 and 9999.
10.
After the year has been entered, the entry can be terminated with OK (select OK and press the PUSH key).
11.
The points 6-10 are to be carried out again for the month, day, hour, minute and second.
12.
Once the date and time is according to your local time, press the SET button in order to validate the change of the date and time
of the HMI and Interrogator
