Condux Gulfstream 35, Product Manual

- 11 -

08785150

Installation & Operation

Pre-Start-up Inspection Checks

This  inspection  should  be  done  prior  to  the 
compressor test.

I.  Check  all  assemblies,  clamps,  fittings,  hose 

connections, nuts, and bolts to ensure they are 
properly tied and secured to the vehicle. This 
is  a  very  critical  area  of  inspection.  The 
vehicle  should  not  be  moved  until  this 
inspection has been completed.

II.  Remove  all  tools,  rags,  and  installation 

equipment from the area.

III.  Check  compressor  oil  level  and  check  all 

valves to ensure they are in correct operating 
position.

IV.  Vacuum all areas that have metal or plastic 

shavings.  Wipe  all  fingerprints  off  unit  and 
vehicle.

Check All Fluid Levels

Position  the  unit  on  a  level  surface  so  that  proper 
amount of fluids can be added.

I.  5 gallons of gasoline

II.  Engine  oil  level  may  have  to  be  topped  off 

after test.

III.  Check compressor oil level

A.  Add oil if needed.

B.  Additional oil may need to be added after 

test.

C.  Top  off  oil  level  to  half  the  sightglass 

when finished with the test.

Machine Documentation

Record all serial numbers for this installation.

A.  Condux International Inc. Serial Number

_________________________________________

B.  Engine Serial Number

_________________________________________

C.  Compressor Serial Number

_________________________________________

D.  Note  any  special  applications  relating  to 

specific installations

_________________________________________

_________________________________________

_________________________________________

Operating Procedure

I.  Read this manual carefully before proceeding.

II.  Verify the service valve is closed.

III.  Pull the choke cable and start engine. If the 

engine is warm or the ambient temperature is 
high, pull the choke knob halfway, or keep it 
fully open.

IV.  Allow 3-5 minutes for engine to warm up

V.  Open service valve