PARTS LIST
2 - Handrail
2 - Stringer (Leg)
4 - Upper tread
1 - Bottom tread
1 - Platform
2 - Mounting block
2 - Adjustable tube
CONFER PLASTICS, INC.
Model 6000 Adjustable Heavy-Duty Inpool Ladder
HARDWARE PACK
26-#10 x 1-1/4" S/S Screw
TOOLS REQUIRED FOR ASSEMBLY:
• Cordless Drill Motor
• 1/8" Drill Bit
• Phillips Screwdriver or screwdriver bits
• Pliers
Step 1.
Snap stringers
into bottom tread.
If necessary lift
the two stringers
off the ground,
with the bottom
tread attached,
and drop them
firmly so that the
stringers “snap”
into the tread
pockets. The
bottom tread
should pivot
freely.
Make sure the
single row of
tread lugs are
facing forward.
Tread Lugs
Step 2.
Two sets of Lug
locations are provided.
Attach 4 upper treads
to the stringers in the
position determined by
the pool height.
x4
Tread Lugs
Step 3.
Step 4.
Using a pair of pliers twist off
the wedges from the end of
the platform and SAVE for
use in step 5.
Wedges
Protrusion
Detach
Wedges
Use upper
lugs for
50" to 54" pools.
Use lower
lugs for
42" to 48" pools.
Secure the
upper treads
by driving
#10 x 1-1/4"
screws through
the recessed,
pre-drilled holes
in the ends of
each tread as
shown. Repeat
for all 4 upper
treads.
Step 5.
Assemble the platform to
the handrails by laying
one of the handrails on a
clean hard surface. Push
the protrusion of the plat-
form into the openings of
the handrail making sure
that the legs of both
handrails are facing in the
same direction. Tap the
4 wedges (from step 4)
into the sides of the
handrails to secure the
platform to the rails.
Step 6.
Coat the adjustable
tubes with a lubricant,
such as liquid dish
detergent, and slip the
mounting blocks all
the way down over the
protruding nubs.
x2
Mounting Block
Adjustable tube
Slide mounting
blocks over nubs
Step 7.
Step 8.
Stringers
Step 9.
Step 10.
Submerge in
water and tilt to a
15° angle to allow
water to fill the
treads.
Attach the handrails to
the ladder assembly,
making certain that the
treads face correctly.
Match
Platform
protrusions
to Handrail
openings
After platform is in
position, tap in the
supplied wedges at
the bottom of each
opening to ensure a
secure fit
Push the
adjustable tubes
with mounting
blocks into
handrails.
Fill both stringers with water to
allow the ladder to be submerged
in the pool.
Push
down
2
3
Confer 6000_9_04 9/23/04 2:13 PM Page 3
