5
Step 13.
Submerge in
water and tilt to a
15° angle to allow
water to fill the
treads.
Note: Ladder
treads must fill
with water to
prevent floating
Step 14.
Place the ladder in
the desired position
on the deck and slide
the ladder assembly
down until the bot-
tom tread meets the
pool liner. Slide the
adjustable tubes with
the mounting blocks
as needed to position
the ladder correctly
on the deck.
Make sure the
bottom tread is
seated with the
pool liner.
Ladder
Assembly.
Slide
adjustable
tubes to
position
against deck.
Step 15.
C.
Drill a 1/8” pilot hole through
the handrail ends at the premarked
locations into the stringers and
repeat this step for the adjustable
tubes and mounting blocks.
B.
Using a cordless drill attach
the mounting blocks with
eight (8) #10 x 1-1/4” screws.
A.
Secure the handrail
using four (4) #10 x 1-1/4”
screws at the pre-marked
locations (two per handrail).
D.
Secure the handrail to the
tubes using four (4) #10 x 1-1/4”
screws at the pre-marked
locations (two per handrail).
WARNING! Using a corded
drill near pool may result in
electrocution.
WARNING! Verify that your chosen location
is level and will be in full view of competent adult
supervision when in use.
