Used to raise ladder when deck is built higher than
pool. Maximum 2 risers. Fill with sand and water,
rest ladder on top. Straps included.
3
SKIMS OFF DEBRIS
Cut cleaning time 75% with skimmer extension
that guides debris directly into your skimmer.
Fits most in-ground and above-ground pool
skimmers. Corrosion-resistant plastic Skim-It
installs in seconds without tools.
For winterizing in cold climates remove ladder
from the pool, and drain water from ladder.
ADDITIONAL ACCESSORIES
For #635-52X Ladder
SKIM-IT
EB 100-3" RISER
Step 7.
Step 8.
Push the adjustable tubes
up into the handrails.
Coat the adjustable tubes with a little
liquid soap. Slide the mounting block over
the tube and slide all the way down until
resting on the nubs.
Step 9.
Step 10.
Place the ladder into the pool and position mounting
blocks on deck. Slide the adjustable tubes up or down
as needed until mounting blocks are sitting flush on
the deck. Ladder
MUST
rest on pool bottom. If not,
EB100 riser(s) are required. (See page 3 to order)
Drill four pilot holes (1/8") through holes in
each block into wood surface. Fasten blocks
to deck using the four #10 x 1-1/4" screws per
mounting block. Drill three holes through each
side of each handrail at the pre-marked
locations. Fasten using three #10 x 1-1/4" screws.
Slide down into position
once mounting blocks
have been fastened.
Flush to deck
