Confer Plastics 8000X, Assembly, Installation And Use Manual

Model #8000X Outside Safety Ladder

Note: Assemble this ladder before assembling the Confer-Step-1X. 
If you have already assembled the Confer-Step-1X it will be 
necessary to remove the handrails (see step #10).

PARTS LIST

HARDWARE PACK  TOOLS REQUIRED  

FOR ASSEMBLY:

 Qty.   

Description

 Qty.    Description

 2-  Handrails
  2-  Stringers / Legs
  4-  Upper Treads
  1-  Bottom Tread
 2-  Shields
  2-  Tread Connector 

(RH & LH)

  1-  Platform (wedges attached)
 

                  see Step #2.

 38-  #10 x 1-1/4” Screw
  2-  1/4-20 x 3-1/2” 
Bolt
  2-  1/4” Washer
  2-  1/4-20 Nylon Nut
  2-  Adjustable Tubes
  2-  Mounting Blocks
  1-   Cable Lock

  *  Cordless Drill
  *  1/8” Drill Bit
  *  Utility Knife
  *  Liquid Soap or  
    Spray Lubricant
  *  Phillips Screwdriver
    or screwdriver bits
 

Platform

Handrail

Stringer / leg

Upper 

Tread

Bottom 

Tread

Tread Connector

Mounting

Block

Adjustable

Tube

Shield

Safe Installation

To reduce the risk of electrocution, drowning, entrapment, falls, or other 

serious injury or death: 

Check building codes/permitting. 

Consult your local Building Department before installation of your pool 

and equipment. Pool/equipment installation must comply with the codes of the authority having jurisdiction 
and may require permits (e.g., building, plumbing, electrical, zoning, etc.).

Use for intended purpose only

•  Use only as swimming pool ladder.
•  This ladder is designed and manufactured for a specific pool wall height and/or deck of the pool - 

check product specification and the height of your pool.

Check that you have all required parts. 

Check the contents of the carton with the Parts list for this step 

system. All parts and hardware are required. If any parts are missing, 

DO NOT attempt to assemble or 

install the steps.

 Instead, call Toll Free U.S. - 800-635-3213 or visit our web site at www.conferladders.

com for assistance.

Select an appropriate location

 - The step system must be located on a solid base.

Follow all instructions

•  For stable, correct assembly and installation, all instructions must be followed completely and in the 

sequence shown.

•  Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used 

during installation.

Cordless drill only - no corded drills near pool.

 Use a cordless drill for assembly and installation. To 

reduce the risk of electrocution, NEVER use a corded drill in or around a pool.

Lift safely. 

 When lifting awkward or heavy loads, have another person help you.

Double check after installation

•  Before using the product, after assembly and installation, go over the instructions and procedures again 

to make sure nothing has been overlooked.

•  Make sure that safety labels are installed and legible.