3
IF YOU HAVE THE CONFER CURVE STEP WITHOUT THE ADD-ON CONTINUE WITH STEP 10.
IF YOU HAVE THE CONFER CURVE STEP WITH OPTIONAL ADD-ON SKIP STEPS 10-18 AND CONTINUE
WITH STEP 19.
Tilt the step
backwards to
expose all four
of the rounded
tabs on the bot-
tom edges.
Step 5
Rotate
90°
Install the first tread
[I] by placing over
the tabs on the side
panels as shown.
While holding part
[I] down on the side
panels tap inward
with a rubber
mallet until locked
in place.
Step 10
Each side panel [A]
requires 20 lbs of sand
split between the two fill holes.
Sand is needed as ballast
to hold step down in the water.
Using a funnel fill the lower hole
completely to the top with sand.
Shake the panel to help settle the
sand, lower hole must be
completely filled. Pour whatʼs left
from the 20 lbs into the upper
fill hole. Using provided cap,
plug the lower fill hole only.
Upper fill hole must remain open.
Repeat procedure to fill the
second part [A].
Step 9
Step 7
Determine which
side will be
facing up on the
front foot pads
[H], # 1 for a
flat bottom pool
or # 2 for a pool
with slight taper
towards the
center, install
both parts [H].
The two back foot
pads [H] will always
be installed with #1
facing up. Place part
[H] over the rounded
tab, strike with a
rubber mallet until
seated onto the
rounded tab. Repeat
to install second
part [H].
Step 8
SAND
Pour
sand into
funnel.
Pour
sand into
funnel.
Repeat step 10 to install
second tread [I].
Step 11
To install the lower
handrail posts [E] first
locate the openings
on part [A] just below
the second tread
marked with #3. Next
insert the tabs on part
[E] all the way into the
openings then tap
down with a rubber
mallet until seated.
Repeat to install the
other part [E].
Step 12
STOP!
STOP!
Installing the
Foot Pads [H]:
If swimming
pool has a flat
bottom, all four
foot pads [H] will be installed with the #1 facing up.
If swimming pool has a slight taper towards the
center, the back foot pads will be installed with #1
facing up and the front foot pads with #2 facing up.
Step 6
#1
#2
prpd.Confer-CurveStepIGr16:Confer-Step-1_R1 1/3/13 2:26 PM Page 3
