Install the add-on panel
[J] by inserting the three
tabs into the three
openings located
towards the back
of step panel [A].
Push the tabs all
the way in,
then tap panel
down with a
rubber mallet
until seated
in openings.
Step 19
Next, install one of the foot pads [H]
onto the tab located on the bottom of
the large flex riser [M] by placing over
the raised tab and striking with a rubber
mallet until seated.
Foot pad [H]
should be installed in the same
direction as the
front foot pads
on base step.
[Refer to steps
7 & 8].
Step 20
Tilt the step back far
enough to slide the
end of large flex riser
[M] up into the slot
located on the front
bottom edge of the
add-on side panel.
Step 21
Insert the
tab on the
other end of
the flex riser
[M] into the
opening on
side panel
[A].
Step 22
Attach the last foot
pad [H] on to the
bottom of the tread
support [N] by placing
over the raised tab
and striking with a
rubber mallet until
seated.
Foot pad [H]
should be installed
in the same position
as the front foot
pads on base step.
Step 23
Locate the notch
on the bottom
edge of the large
flex riser [M].
Slide the step
support [N] under
then rotate up
making sure part
is in notch.
Step 24
5
S
L
K
J
R
Q
P
M
H
N
O
Additional Parts for Step Add-On
2 - Foot pads [Part H]
1 - Add-on panel [Part J]
1 - Short handrail post [Part K]
1 - Long handrail post [Part L]
1 - Large flex riser [Part M]
1 - Tread support [Part N]
1 - Large curved tread [Part O]
1 - Medium flex riser [Part P]
1 - Medium curved tread [Part Q]
1 - Small flex riser [Part R]
1 - Small curved tread [Part S]
1 - Plug [WG] (installed in add-on panel)
CONFER CURVE STEP
ADD-ON INSTRUCTIONS
The curve add-on can only be installed on the right side of the step as you
are facing it. The add-on requires an additional 30 lbs. of sand.
prpd.Confer-CurveStepIGr16:Confer-Step-1_R1 1/3/13 2:26 PM Page 5
