Step 7.
Secure each
step by tapping
a locking wedge
(saved from Step
2) between the side
panel and the top
surface of the
step protrusions.
Step 6.
Push the second side panel firmly down on the step
protrusions. It may be necessary to tap the side panel
using a hammer and block of wood until seated
correctly.
Push down firmly
4
Step 8.
Red plug
Threaded cap
Step 10.
If you are fastening
the pool entry system
to a deck: Attach the
deck connector to the
top step using the
three (3) 1/4-20x1”
screws and hex nuts
(nuts are installed on
underside of deck
connector).
NOTE: If you are fastening
two units together, do not
attach deck connector. Skip
to Page 5 “Joining two PES
Pool Entry Systems”.
The maximum
adjusted height
of the Entry
System is
(54
1
/
2
) inches.
3 1/4-20 x 1” screws
3 hex nuts
Step 11.
Attach the anti-entrapment panel (item 7)
to both sides of the unit as shown. Position and push firmly
down into base until it locks securely into place.
Note: Anti-Entrapment panels are not needed if the
unit is left at 48”
.
Step 9.
Use a mallet to
tap each base
onto the height
adjusters.
With a
screwdriver, turn the height
adjusters to the desired height as
determined in Step 1.
Proper exposed length
is measurement #2
minus 48-1/2”
To attach the base,
position the unit as
shown.
Proper exposed length is
measurement #1 minus 48-1/2”
WARNING!
Using
a corded drill near
pool may result in
electrocution.
On the bottom edge
of each side panel
is a drain hole. Plug
these holes by first
inserting a (Red)
plug into the hole
and then covering
with the threaded
cap.
