background image

6

Order online @  

www.conferladders.com

3-PESX-89A

PES-1X / PES-DBLX  5M  2/19

Removal and storage of Pool Entry System:

In cold climates the Entry System must be removed from the pool 

and drained to prevent freezing and cracking. 

WARNING! Pool step will be heavy and must be lifted from within 
the pool. Have additional help when removing from swimming 
pool. Do not attempt to remove by yourself. 

To remove the unit disconnect it from the deck (or the outside unit), 

pull large plugs and tip it so that some of the water drains from the 

large fill openings. Once the unit is lighter it will become buoyant 

so that it can be turned onto its side and the bottom drain caps and 

plugs can be removed. With the unit on its side, slowly pull the Entry 

System from the water allowing the water to drain out of the unit. 

Once the unit is out of the pool be sure that all the water drains out. 

If desired the unit can be disassembled for winter storage. Use a flat 

blade screwdriver to remove the locking wedges and carefully pull 

the side panels away from the steps. 

(Be sure to save all caps and 

locking wedges for reassembly).

To reinstall, follow installation instructions steps 10-12.

OPTIONAL ACCESSORY

SKIM-IT—SKIMS OFF DEBRIS.  

Cut cleaning time 75% with skim-

mer extension that guides debris 

directly into your skimmer.  

Fits most in-ground and above-

ground pool skimmers. Corrosion-

resistant plastic Skim-It installs in 

seconds without tools.

CONFER PLASTICS INC. FIVE YEAR WARRANTY

Confer Plastics Inc. warrants their swimming pool ladders and steps to be free from 

defects in workmanship for five years from date of purchase.

DO NOT RETURN DEFECTIVE PART TO DEALER

E-MAIL CONFER PLASTICS AT:   LADDERS@CONFERPLASTICS.COM  

A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,  

PROOF OF PURCHASE AND YOUR CONTACT INFORMATION. 

INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT:  716-694-3102 

OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU  

WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND  

THE SHIPPING/HANDLING CHARGES.

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.

Confer Plastics Inc.

97 Witmer Road

North Tonawanda, N.Y. 14120-2421

Safe Use

To reduce the risk of drowning, entrapment, falls, paralysis, electrocution,  

or other serious injury or death:

Use step system properly.

• No diving or jumping from steps

 - shallow water; risk of paralysis or death.

• ONE PERSON ON THE LADDER/STAIR AT A TIME.

• Illuminate the steps when using the pool at night.

Weight limit - 400 lbs maximum.

 Exceeding maximum weight may cause the stairs to fail.

Secure stairs when not in use.

 When pool is not in use, make sure gate is closed and locked.

Watch children at all times

 when they are in or around water to help prevent drowning.

Summary of Contents for PES-1X







Reviews: