BILL OF MATERIALS
Parts List
Required
Part #
Gate 1
6-Gate-01
Hinge Mounting Post
1
6-Gate-02
Latch Mounting Post
1
6-Gate-03
Hardware Pack
Required
Part #
#10 x 1-1/4” Screw
20
3-00-14C
#7 x 1/2” Screw
8
3-Gate-01
Padlock
1
3-00-03
Gate Latch with Latch Bar
1
3-Gate-06
Gate Closer
1
3-Gate-07
Step #1
Spread open the flange of the
hinge mounting post and slide
it down over the
right
side
panel until the bottom edge of
the hinge post and the bottom
edge of the side
panel are even.
Step #2
Fasten the hinge post to the
side panel using six of the
#10 x 1-1/4” self-tapping
screws at the pre-marked
spots on each side of the
hinge post (3 per side).
Step #3
Slide the open gate hinge
through the hinge post pin
opening and wrap the gate
hinge around the hinge pin.
Fasten the hinge at the four
pre-marked spots using the
#7 x 1/2” self-tapping screws
(4 per hinge).
#10 x 1-1/4”
Self-tapping
Screw
#7 x 1/2”
Self-tapping
Screw
2
Tools Required
Cordless Drill
1/16 Drill Bit
Phillips Screwdriver Bit
Silicone Spray or
Spray Lubricant
POOL ENTRY SYSTEM GATE ASSEMBLY
MODEL # PES-G
