4
Printed in USA
S
MADE IN THE USA
3-STEP-02-X
CP-STEP-1X-US 1-19
CONFER PLASTICS INC. FIVE YEAR WARRANTY
Confer Plastics Inc. warrants their swimming pool ladders and steps to be free from defects in
workmanship for five years from date of purchase.
DO NOT RETURN DEFECTIVE PART TO DEALER
E-MAIL CONFER PLASTICS AT: LADDERS@CONFERPLASTICS.COM
A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,
PROOF OF PURCHASE AND YOUR CONTACT INFORMATION.
INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT: 716-694-3102
OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU
WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND
THE SHIPPING/HANDLING CHARGES.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Confer Plastics Inc.
97 Witmer Road
North Tonawanda, N.Y. 14120-2421
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 800-635-3213
FAX 716-694-3102
www.conferladders.com
Options available – To make an up-and-
over step system with gate as shown
for your pool purchase our #Step-Enc
Enclosure Kit and an additional #Step-1X.
TO WINTERIZE YOUR POOL
We suggest removing your Confer-Step from the pool for the off-season months.
WARNING! Pool step will be heavy and must be lifted from within the pool. Have additional
help when removing from swimming pool. Do not attempt to remove by yourself.
If your Confer-Step-1x is attached to a deck: Two people are required for this operation and it is
best to remove the unit while the water is still warm enough so that one person can get into the
pool. Disconnect the mounting brackets from the deck. The person in the water can lift the unit up
while the person on the deck helps to pull and guide the unit onto the deck. After the unit is on the
deck, and the water has drained out of the steps, lay the unit on it’s back side so that most of the
water drains from the side panels.
If getting into the water is not an option the unit can be removed by both people standing on the
deck and lifting and tilting the unit to drain some of the water from the steps. After the unit is light
enough carefully lift it from the pool. Caution: Use care when lifting the unit. It will weigh at least
130 lbs.
If you have the Confer-Step Enclosure System or Connector System: disconnect the two units by
removing the center platform/side rail assembly at the top of the steps.
WARNING! Do not stand on the top step of the outside unit as it may tip.
Lift up the unit inside the pool and tilt it so that water drains out of the steps. Once it is light enough
carefully lift it over the side of the pool, lay the unit on it’s back side and allow most of the water to
drain from the side panels.
The Confer-Step can be covered, if desired, and stored outdoors.
To reinstall, follow installation instructions steps 10-12.
Safe Use
Contact your dealer or check online at
www.conferladders.com
To reduce the risk of drowning, entrapment, falls, paralysis, electrocution, or
other serious injury or death:
Use step system properly.
• No diving or jumping from steps
- shallow water; risk of paralysis or death.
• ONE PERSON ON THE LADDER/STAIR AT A TIME.
• Illuminate the steps when using the pool at night.
Weight limit - 400 lbs maximum.
Exceeding maximum weight may cause the stairs to fail.
Secure stairs when not in use.
When pool is not in use, make sure gate is closed and locked.
Watch children at all times
when they are in or around water to help prevent drowning.
