Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version,
connect the hood to the chimney using
either a flexible or rigid pipe Φ 150 or
Φ 120 mm, the choice of which is left to
the installer�
• If to install a Φ 120 mm air exhaust connection, insert the
reducer flange
3
on the hood body outlet�
• Fix the pipe
4
in position using pipe clamps (not supplied)�
• Remove possible charcoal filters�
Upper Decorative Chimney
• Insert the upper chimney 2�2 into the lower chimney 2�1 and
drag it up to bracket 21 on the horizontal line C
• Fix the chimney 2�2 at bracket 21 with 2 screws 12�
Use
Speed adjustment.
After the hood is switched on, a beep sound heard and all key
lights are lightened for 1 s, indicating the hood has been powered
on� Under the condition the hood power-on:
•
Power Key:
control the motor power, under standby state,
press the “power” button, “power” key light is on, the motor
starts up at low speed, digital screen displays setting 1; under
power-on state, press the “power” button, enter 3-min-delay-
shutdown state, setting switched to low speed, the power
key flashes at one second interval, which means entering
delay-shutdown state; under delay-shutdown state, press
the “power” button, it’s shut down immediately (motor stops
running)�
•
Light Key:
independently control the light on and off free
from the effect of other keys�
• Press it once, the light is on, meanwhile the light key light is
on; press again, the light is off and light key light is off too�
•
Plus (+) Key:
valid under power-on state, press plus (+) key
once, motor speed increased one setting, digital tube displays
corresponding setting� When the plus (+) key is pressed down,
plus (+) key light is on� When at the highest setting, only give
out key touch sound, the setting no longer changes�
•
Minus (-) Key:
valid under power-on state, press “minus (-)”
key once, motor speed decreased one setting, digital tube
displays corresponding setting� When the “minus (-)”key is
33
32
GB
GB
