Copyright
©
2020
congatec
AG
ICWLm12
24/62
5.1.4
Power-On Control Jumper
The conga-IC370 provides jumper X61 for controlling the power-on control feature.
Table 15 Auto Power-On Control
Jumper
Configuration
1-2
Disable auto power-on control (ATX mode)
2-3
Enable auto power-on control (AT mode)
Note
Jumper X61 has no effect if the power-on control is enabled in the BIOS setup menu.
Connector Type
X61 : 1 x 3-pin, 2.5 mm pitch pin header
5.1.5
CMOS Battery Header
The conga-IC370 provides a CR2032 CMOS battery which is attached to battery holder M24. The battery supplies power to maintain the CMOS
settings and real time clock.
Warning
Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer’s instructions.
X61
Pin 3
Pin 1
M24
