Copyright
©
2020
congatec
AG
ICWLm12
35/62
Note
1.
Set the eDP panel voltage (3.3 V, 5 V or 12 V) with jumper X29
2.
3.3 V input signal
3.
Set the voltage level (3.3 V or 5 V) with jumper X65
4.
Set the voltage level (5 V, 12 V or 19 V) with jumper X30
Connector Type
X27: 0.5 mm, 40-pin ACES connector
Possible Mating connector: ACES 88441-40 or ACES 50204-40
5.3.4
Panel Voltage Selection Jumper
The conga-IC370 supports 3.3 V, 5 V and 12 V LCD panels. Use jumper X29 to set the LVDS or eDP panel voltage.
Table 22 X29 Pinout Description
Jumper
Panel Voltage
2-4
3.3 V (default)
3-4
12 V
4-6
5 V
Connector Type
X29: 2.54 mm, 2 x 3-pin header (without pins 1 and 5)
X29
Pin 2
Pin 6
No Pin
No Pin
Pin 3
