Please keep these instructions and read them carefully before using the tile cutting machine.
A. Safety instructions
- Keep away from children.
- The tile cutting machine is fitted with a replaceable cutting wheel. Check the cutting wheel‘s backlash and turnability before use and correct if necessary.
- Clean the machine after use and store in a safe, dry place.
- Not suitable for natural stone tiles and/or heavily structured tiles.
- Place the machine on a level, clean and solid surface before use.
- Caution: Cut/broken tiles have sharp edges.
- Problems can arise with tiles that have been fired multiple times. Ask a specialist (tiler).
B. Cutting and breaking tiles
- Mark the break line with pencil/permanent marker.
- Push the tile against the mechanical stop, the glazed side must face upwards.
- Position the cutting wheel at the beginning of the line marked.
- Press the cutting lever/cutting wheel downwards, onto the tile, pushing forward along the marking. Make sure that there is a uniform grinding noise. Repeat
the process if necessary.
- Position the breaking device at the front on the tile and press the handle downwards carefully. IMPORTANT: The cutting wheel must not touch the tile!
C. Maximum and minimum thickness of the material to be cut; max. cutting length depending on tiles’ material characteristics.
D. Care
- Clean the machine carefully after use. Allow the machine to dry completely after use. Lubricate the guide tubes (household oil, COX591100) after each clea-
ning/use.
E. Changing the cutting wheel
- Replace the cutting wheel with an original replacement part from the manufacturer only. Unscrew the nut of the cutting wheel bracket‘s axle and remove the
axle. Replace the cutting wheel, insert and tighten the axle. The cutting wheel must run smoothly and must have just a little backlash. Lubricate slightly.
F. Disposal
- Defective machines that cannot be repaired must be sent for disposal of recyclable material.
6
- 10
mm
Conmetall Meister GmbH
Hafenstraße 26
29223 Celle
·
GERMANY
www.conmetallmeister.de
max. 500 mm
max. 350 x 350 mm
