1. No weight displayed?
Check to see if the scale is powered up and started up. If not, please refer to the
Section “Preparation Before Use”.
2. Why does the display read
“Lo”?
Battery is running low. Replace the battery.
3. You must have bare feet to make this measurement.
To get the most accurate and consistent reading, wipe your feet with a damp cloth, leaving them slightly
damp before stepping on the scale.
4. If the scale displays all icon for more than 6 seconds?
Calibration error. Step off the scale and wait until the scale automatically turns off. Start the scale again
by pressing firmly on the scale platform to re-calibrate the scale. The display shows “0.0” and then turns
off. The scale is ready for use again.
5. The message displays “ Err ”?
Overload Warning. The maximum weight capacity of the scale (440 lbs / 200 kgs) has been exceeded.
Remove the weight immediately; otherwise, permanent damage to the scale will occur.
6. The message displays “Err1”?
Contact error. Clean bottom of feet with a damp cloth, leave slightly damp, and repeat measurement
again, maintaining maximum contact between your feet and the metal sensors.
7. The scale displays “Err L” when estimating body fat, body water, muscle mass and bone mass values?
Estimated values are lower than the minimum values the scale can estimate. Moistening your feet may
help to improve the electrical contact.
8. The scale displays “Err H” when estimating body fat, body water, muscle mass and bone mass
values
?
Estimated values are higher than the maximum values the scale can estimate. Moistening your feet may
help to improve the electrical contact.
1.
OVERLOAD WARNING:
the maximum weight capacity of this scale is 440 lbs / 200 kgs. Remove the
weight immediately when the scale displays “ Err ”; otherwise, permanent damage to the scale will
occur.
2.The product is intended for home / consumer use only; it is not intended for professional use in
hospitals or medical facilities.
3.Do not disassemble the product. Other than replacing the batteries, it contains no user serviceable
parts.
4.Clean after use with a lightly dampened cloth. Do not use solvents or immerse the product in water.
5.Your scale contains sensitive electronic parts. Avoid rough treatment. Do not drop, kick, or jump on it.
Treat it with care to ensure the best performance.
